This is going to be my last post for this little series I've been doing, mostly because I need a stopping point or I could go on forever with embarrassing stories. So, here's a couple more embarrassing moments from my freshman year of college.
For about a week straight sometime during spring semester, someone had put a wooden box with a mannequin on top of it in the caf lobby for some sort of art project. Every day that week, the mannequin would be wearing something different and people could write down some type of opinion about it's appearance. At the end of the week when we were leaving dinner, we walked out to the lobby to see that the entire display was gone, with the exception of the box. Knowing that our other friends were still in dinner and would be walking past shortly after, I decided I would stand on the box and then pose when we saw our other friends. After a couple minutes, someone approached me. He then asked for his box, which I was still standing on. After that, I never stood on something unless I knew someone wouldn't come and ask for it.
Towards the end of spring semester, some of my friends and I were all working on our final film projects. I recruited a couple of them to help me film a small part of mine, where they would stand by a tree and I would be in the tree filming them for the right angle. Obviously, this required me to climb up into the tree. I've never climbed a tree before, but I didn't think it would be too hard. In the process of climbing the tree, I was reminded of just how short I am, because I realized I was too short to go any higher than the first branch. One of my other friends offered to climb the tree and film the part for me, so I decided I would climb down and let her film it. Unfortunately, I couldn't figure out how to get down (I'll blame it on being blonde), so another one of my friends had to half pull me out of the tree while I attempted to climb down. Needless to say, I have yet to attempt to climb another tree.
Tuesday, August 12, 2014
Tuesday, August 5, 2014
Oreo Stuffed Chocolate Chip Cookies
I've always wanted to try to make Oreo stuffed chocolate chip cookies and I finally decided to the other day when I had a little free time, and I am so happy I did. They are so delicious, even my Oreo-hating grandmother absolutely loved them and ate several. They're super simple to make, even though I though I had ruined them for a minute.
All you have to do is take some cookie dough - I used 2 pieces of Toll House pre-cut dough for each Oreo - and put it around each Oreo, then bake them following the directions on the cookie dough package. The problem I thought I had encountered was that some of the dough spread out when they were baking, which made them look weird, but then I realized I could just pick up the part with the Oreo in it and it would look perfectly fine. Plus, that left me with a pile of chocolate chip cookie pieces.
These seriously taste so good, they're like a little piece of chocolate heaven, plus they're extremely easy to make, so I would strongly encourage you to try them.
All you have to do is take some cookie dough - I used 2 pieces of Toll House pre-cut dough for each Oreo - and put it around each Oreo, then bake them following the directions on the cookie dough package. The problem I thought I had encountered was that some of the dough spread out when they were baking, which made them look weird, but then I realized I could just pick up the part with the Oreo in it and it would look perfectly fine. Plus, that left me with a pile of chocolate chip cookie pieces.
These seriously taste so good, they're like a little piece of chocolate heaven, plus they're extremely easy to make, so I would strongly encourage you to try them.
Saturday, August 2, 2014
DIY Laptop Sleeve
The other day, I finally decided to start going through my stuff and deciding what I still need to but for the new school year. I quickly realized I would need a laptop case. The backpack I carried this past year had a built in case, but I don't really like that backpack anymore, and the one I want doesn't have a built in case. The only problem is, laptop cases and sleeves can get pretty expensive. So I decided I would try and make my own, and I am so happy I did. It turned out pretty well, especially for someone who doesn't really sew, plus it was super simple and cost less than $3 to make (I only spent $8.84 on all the fabric and fleece and I have enough left over to make two more, so it cost about $2.95).
Supplies I used:
Fabric (I got 1 yard, but only used about 1/3 of it)
Fleece (I got 2 yards so I could double it and I still have a bunch left over)
Scissors
Measuring tape
Pencil
Ruler/yard stick
Sewing machine
Step 1: I measured my laptop by wrapping the measuring tape all the way around the laptop, and then diving the measurements in half (that way I had the length plus the height and the width plus the height). My laptop measured 31" x 25.25", so when divided in half it was 15.5" x 12.625". I then realized I didn't need the width because I could just use the strip of fabric after I cut it to the right length to make the flap and then cut off the little amount of excess fabric. So I took the length measurement and added 2.5", making it 18", so I would have enough extra to work with.
Step 2: I turned the fabric sideways so the pattern on it would go the direction I wanted and then measured with the yard stick 18" in and then drew a line with the pencil to make sure it would be straight. I then cut out the fabric, ending with a strip of fabric 18" x 36" (Since it was sideways, I used the whole yard length for folding over to make the case and flap).
Step 3: I repeated step 2 with the fleece, which I also turned sideways so I could just fold over the two yards into one yard since I wanted to double the fleece.
Step 4: I folded the fleece in half so that it was the same length as the fabric and laid it out flat. I then laid the fabric on top of it, with the right side facing up, this was I could see the stitches since I was using white thread and those sides were going to be flipped over when I did the final sewing.
Step 5: I sewed all the way around twice, just to make sure the fleece was attached really well to the fabric. Then, I cut off all the extra bulkiness left over from sewing the fabric and fleece together.
Step 6: I flipped up the amount needed for the pocket, with the right side of the fabric facing inward. For this, I just put my laptop on top of it and added an extra 1.5"-2". Just eyeball it and so it has enough room to store your laptop, but enough extra wiggle room and room for sewing the top border when you're done. Make sure you leave the rest of it for the flap.
Step 7: I sewed the two sides of the pocket. The bottom doesn't need sewn because it's just folded over and the top part will be done separately.
Step 8: I flipped it right side out and folded over the top side of the pocket and sewed it over a little so it would be a straight edge.
Step 9: I folded over the three sides of the flap and sewed them.
Step 10: I cut off all extra bulk from the fleece and fabric so it was nice and neat looking.
I'm really happy with you it turned out and it will definitely serve it's purpose. And it was definitely worth it to spend an hour or two making it as opposed to buying one for ten times the price.
Supplies I used:
Fabric (I got 1 yard, but only used about 1/3 of it)
Fleece (I got 2 yards so I could double it and I still have a bunch left over)
Scissors
Measuring tape
Pencil
Ruler/yard stick
Sewing machine
Step 1: I measured my laptop by wrapping the measuring tape all the way around the laptop, and then diving the measurements in half (that way I had the length plus the height and the width plus the height). My laptop measured 31" x 25.25", so when divided in half it was 15.5" x 12.625". I then realized I didn't need the width because I could just use the strip of fabric after I cut it to the right length to make the flap and then cut off the little amount of excess fabric. So I took the length measurement and added 2.5", making it 18", so I would have enough extra to work with.
Step 2: I turned the fabric sideways so the pattern on it would go the direction I wanted and then measured with the yard stick 18" in and then drew a line with the pencil to make sure it would be straight. I then cut out the fabric, ending with a strip of fabric 18" x 36" (Since it was sideways, I used the whole yard length for folding over to make the case and flap).
Step 3: I repeated step 2 with the fleece, which I also turned sideways so I could just fold over the two yards into one yard since I wanted to double the fleece.
Step 4: I folded the fleece in half so that it was the same length as the fabric and laid it out flat. I then laid the fabric on top of it, with the right side facing up, this was I could see the stitches since I was using white thread and those sides were going to be flipped over when I did the final sewing.
Step 5: I sewed all the way around twice, just to make sure the fleece was attached really well to the fabric. Then, I cut off all the extra bulkiness left over from sewing the fabric and fleece together.
Step 6: I flipped up the amount needed for the pocket, with the right side of the fabric facing inward. For this, I just put my laptop on top of it and added an extra 1.5"-2". Just eyeball it and so it has enough room to store your laptop, but enough extra wiggle room and room for sewing the top border when you're done. Make sure you leave the rest of it for the flap.
Step 7: I sewed the two sides of the pocket. The bottom doesn't need sewn because it's just folded over and the top part will be done separately.
Step 8: I flipped it right side out and folded over the top side of the pocket and sewed it over a little so it would be a straight edge.
Step 9: I folded over the three sides of the flap and sewed them.
Step 10: I cut off all extra bulk from the fleece and fabric so it was nice and neat looking.
Subscribe to:
Posts (Atom)